If not look in device manager for the serial port its arrived on and use that in signgo. If your lucky it will give the serial port to use.
#Jk721 cutting plotter driver install#
Install the USB driver that came with it then connect up the USB cable and 'Found new hardware' should appear install. For USB this type generally uses a prolific or FDTI chipset in the plotter rather than implementing a true USB printer driver interface.
I have finally managed to setup the goldcut jk series cutter/plotter that i purchased from lovecut last year!!! I put in the cd and it just keeps saying. Help with Jinka Goldcut JK series drivers I have just had to buy a new computer due to a hard drive failure, unfortunately I cannot find the driver disk for my Goldcut JK series cutter. Hardware handshake (normally rts/cts for this type) Use a generic Serial driver or something like the redsail 720C driver. If its the usual motherboard then its running at 9600 baud, 8 data, no parity and 1 stop bit. USB or serial, I hope the plotter came with its serial cable as some use straight through some cross over types.įor serial use the cable in the box. Appears to be another dmpl/hpgl serial plotter.
0 kommentar(er)
